JRP

[Carlos Aguilera Sr]

What do I need to do to the configuration file to get JRP to work.



I am using Windows XP with the Hercules GUI.



TK3UPDT has a defined 3780 RJE printer, it also has a 3284 printer define at
1C7, but Hercules does not recognize 3284 as a valid device, also the RJE
printer is a BSINC definition but there is no port number I can use, maybe
it has but I do not know which it is or the device number to use.



I am a tiny bit confused, please help. :-)



Thanks



Carlos Aguilera Sr.

1401 Liggates Rd.

Lynchburg, VA 24502

434-401-4828

Carlos-FiVMtmHp2a9Wk0Htik3J/***@public.gmane.org

[halfmeg]

Post by Carlos Aguilera Sr
What do I need to do to the configuration file to get JRP to work.
I am using Windows XP with the Hercules GUI.
TK3UPDT has a defined 3780 RJE printer, it also has a 3284 printer
define at 1C7, but Hercules does not recognize 3284 as a valid
device, also the RJE printer is a BSINC definition but there is no
port number I can use, maybe it has but I do not know which it is or
the device number to use.
I am a tiny bit confused, please help. :-)

There was a lengthy discussion on JRP earlier in the forum. You may find something in this thread:

http://tech.groups.yahoo.com/group/turnkey-mvs/message/1732

which will assist you.

Hercules not recognizing a specific device can sometimes be resolved by substituting a device which it does know about. Defining a 3287 for 1C7 in the Hercules configuration may help.

The RJE port is defined on the device statement in the Hercules config file. Maybe I left it out of the TK3UPD.conf as was concentrating on adding 2703 and 3705 devices.

Will look into that.

Phil

[scott]

In the hercules configuration file put in the device address of the
printer and then the device name of 3287. The address you put in the
hercules configuration file must be valid in both MVS as being defined
as a 3284 and as well as being defined in VTAM.

Scott

Post by Carlos Aguilera Sr
What do I need to do to the configuration file to get JRP to work.
I am using Windows XP with the Hercules GUI.
TK3UPDT has a defined 3780 RJE printer, it also has a 3284 printer
define at 1C7, but Hercules does not recognize 3284 as a valid device,
also the RJE printer is a BSINC definition but there is no port number
I can use, maybe it has but I do not know which it is or the device
number to use.
I am a tiny bit confused, please help. J
Thanks
Carlos Aguilera Sr.
1401 Liggates Rd.
Lynchburg, VA 24502
434-401-4828